Hi guys,
I'm having some difficulty trying to program an EasyIO FW-08 Controller. Being a complete newbie maybe you guys could give me some advice on what I'm doing wrong. I have a 24 Volt power supply as well as a Cat 5 cable that's connected to the computer. I've downloaded the most recent version of CPT Tools. I've reset the controller to the factory IP address of 192.168.10.8. However, when I go to open the controller it comes up with error code 1, error info: timeout.
I've tried multiple different IP addresses with no luck. Any idea what I'm doing wrong?
Thanks in advance,
-Ron
|